Induction Slide-In Ranges
| # | Error | Solution |
|---|---|---|
| 1 | dE and the cooking zones do not heat up | The demo mode has been activated. 1. Disconnect the appliance from the power supply for 30 seconds by switching off the circuit breaker or fuse in the electrical panel. 2. Touch any control on the appliance within the next 3 minutes. |
| 2 | E and a number appears on the display and the control beeps | An electronics fault/error has occurred. 1. Press any button to stop the beeping. 2. Reset the oven if necessary. 3. Call Bosch Customer Support at 1-800-944-2904 for assistance or to book a service visit. |
| 3 | E7015 | The electronics have overheated. The corresponding cooking zone has been switched off. 1. Wait until the electronics have cooled down sufficiently. 2. Touch any control element on the appliance. 3. When the error message disappears and the electronics have cooled down sufficiently, you can continue to cook. |
| 4 | E9000 | The supply voltage is incorrect. It is outside the normal operating range. Contact your electrical utility provider or contact Bosch Customer Support at 1-800-944-2904 for assistance. |
| 5 | E9010 | The supply voltage is incorrect. It is outside the normal operating range. Contact your electrical utility provider or contact Bosch Customer Support at 1-800-944-2904 for assistance. |
| 6 | E9011 | The appliance is not connected properly. 1. Disconnect the appliance from the power supply. 2. Make sure the appliance has been connected as shown in the circuit diagram. |
| 7 | F1 | The cooking zone has overheated. It has switched off to protect the work surface. 1. Wait until the electronics have cooled down sufficiently. 2. Switch the cooking zone back on and you can continue to cook. |
| 8 | F2 | The electronics have overheated. The corresponding cooking zone has been switched off. 1. Wait until the electronics have cooled down sufficiently. 2. Touch any control element on the appliance. 3. When the error message disappears and the electronics have cooled down sufficiently, you can continue to cook. |
| 9 | F4 | The electronics have overheated. The corresponding cooking zone has been switched off. 1. Wait until the electronics have cooled down sufficiently. 2. Touch any control element on the appliance. 3. When the error message disappears and the electronics have cooled down sufficiently, you can continue to cook. |
| 10 | F5 and a signal tone | There is hot cookware near the control panel. The cooking zone has switched off to protect the electronics. 1. Remove the cookware from the control panel. 2. Wait a few seconds. 3. Touch any control element on the appliance. 4. When the error message disappears and the electronics have cooled down sufficiently, you can continue to cook. |
| 11 | F5 and the power level flashes alternately with a signal tone | There is hot cookware near the control panel. The electronics are at risk of overheating. Remove the cookware from the control panel and you can continue to cook. |
| 12 | F6 | The cooking zone has overheated. It has switched off to protect the work surface. 1. Wait until the electronics have cooled down sufficiently. 2. Switch the cooking zone back on and you can continue to cook. |
| 13 | F8 + H/h and the cooking zones are not heating | The cooking zone has been operating continuously for an extended period of time without interaction. The automatic time limitation has been triggered. 1. Simply touch any control element on the cooktop. 2. You can set the cooking zone and continue to cook. |
| 14 | U400 | The supply voltage is incorrect. It is outside the normal operating range. Contact your electrical utility provider or contact Bosch Customer Support at 1-800-944-2904 for assistance. |